Repairing Pipe Leaks On Your Own

No matter how big or small it is, leaking pipes can create extreme changes on your water bills. However, fixing minor leaks is actually easy and is something that you can manage to do without calling a plumber. Here are some ways on how you can repair pipe leaks by yourself.

Fixing Leaks Through Tape

Fixing Leaks Through Tape

This is considered to be the easiest and cheapest way that anyone can do to fix small pipe leaks. All the material you would need is an electrical or duct tape. The basic principle here is that you should cover the leak using the tape. To effectively stop the leak, you should start wrapping the tape before the leak itself on your water pipe. Wrap it in a diagonal manner. Make sure you have covered the entire leaking area. You need to extend the warp before and after the leaking area.

Fixing Leaks By Epoxy

Fixing Leaks By Epoxy

This method is best used if your leaking problem is situated at pipe fittings and joints. You can get epoxy from your local hardware store. First off, you should cut off the water supply. Then you need to drain all the water from the pipes. Water Purging can be done by letting the faucet run until no more water comes out.

After purging the water, dry out the pipes and clean it using steel wool. Make sure that the pipes are dry and clean, since applying epoxy on a wet pipe can give unpleasant results. If you are sure, then apply the epoxy and let it dry. Refer to the epoxy’s packaging on how long you should let it stand to dry up. Avoid using the pipeline if the epoxy is still wet.

Fix Leaks Through A Pipe Clamp

Fix Leaks Through A Pipe Clamp

You can use a pipe clamp to fix your leaks. However, you should buy a clamp that has the right size to fit your leaking pipe. Once you have purchased a clamp, clean out your pipe. Be careful in cleaning it, and make sure that you do this well. Wrap your pipe in a rubber pad which should be placed over the area where the leak is. Put the pipe clamp over it when the pad is already in place. And secure it by screwing the clamp.

Fixing Leaks Through Hose Clamps

Using a host clamp is kind of similar to using a pipe clamp. However, this is to be only used on smaller leaks. You can start by wrapping the pipe with a rubber pad. Once the pad is placed over the leaking area, put one or two hose clamps over it and tighten the pad by securely screwing it.

Fixing Leaks Through C-Clamps and Blocks

If your pipe is of a small size, then you can make use of a small sized c-clamp to patch it. Start by placing a rubber pad directly on top of the leak. After that, put a small wooden strip or block on top of it. Get the c-clamp and place it over the fixture to hold everything in place. You use the blocks as protection for the pipe from the pressure given by the c-clamp.

Fixing Leaks Using Tin Can Clamps

Here, what you would need is a tin can. Start off by cutting the ends off the can and cutting it up one side. Get the half of the can and bend its ends so that they are flat and could meet. This is like a homemade pipe clamp.

Get a rubber pad and place it over your leak. Above the rubber pad, place your homemade clamp. A c-clamp and wooden blocks can also be used to tighten the fixture.

Leave a Reply

Your email address will not be published. Required fields are marked *